IMMIX

Designed so operators can focus on cows.
And milk more cows per hour.

Sleek and simply designed
to maximize operator efficiency

One button automation for fast and easy unit attachment
IMMIX starts with a sleek, stainless steel, air retraction cylinder
that easily mounts to the stall with no obstructive shroud or stall
control to maneuver around. Simple “One Button Automation” is
built right into the base of the retraction cylinders. Operators
simply push the button at the bottom of the retraction cylinder and
grab the milking unit for fast and easy unit attachment.

Easy to see milking status lights.
Milking status lights are built into the bottom of the retraction cylinder so operators can easily see milking
status for every cow in the parlor. Once IMMIX senses milk is slowing, an orange light near the start
button at the bottom of the cylinder illuminates indicating the end of milking and pending retraction. A blue
light indicates cows that are milked in manual milking mode.

Operators focus on cows and maximize milking efficiency.
With IMMIX, operators easily move from cow to cow. One button automation at the base of each
retraction cylinder. Exceptional visibility of milking status up and down each side of the parlor, lets
operators focus on cows, not equipment. And when the focus is on cows, operators maximize milking
efficiency and parlor throughput.

Smart, accurate and incredibly simple to adjust so you can
optimize every milking.

Accurate high capacity sensing and unobstructed milk flow.
Harvesting the most milk from every cow requires reliable,
accurate sensing and unobstructed milk flow. IMMIX milk flow
sensors use electronic sensing that accurately detects milk flow.
The uniquely designed, high capacity 7/8” all-in-one milk flow
sensor incorporates a compressed air activated shut-off and
provides stable vacuum to the teat. Even under peak milk flow
rates from high producing cows.

Change settings in seconds with a keystroke at your computer.
IMMIX detachers are computer networked and controlled. All settings for the
detachers, from milking delays to detach signals, can be changed in seconds with a
keystroke at your computer. No need to open a stall control box in the parlor. No need
to call a technician. No interruption of milking. You decide the settings to optimize
milking, and fine-tune the settings to get the most out of every cow, every milking.

One control box and circuit board for two stalls.
Designed to be easy to install, service, and maintain.
Streamlined control simplifies installation, service, and maintenance.

Fewer control boxes and remote mounting for a streamlined installation.
Since only one IMMIX control box is needed for every two IMMIX detachers, and
detacher controls are remotely mounted, milking systems installations are less
complicated. Fewer wires and hoses compared to conventional detacher systems
create less clutter at the stall and streamline the parlor installation. Plus with fewer
controls and wires, IMMIX is easier to install, service, and maintain.